User`s manual

MediaPack
SIP User's Manual 94 Document #: LTRT-65408
Table 5-14: Number Manipulation ini File Parameters (continues on pages 93 to 95)
Parameter Description
NumberMapIP2Tel
Manipulate the destination number for IP to Tel calls.
NumberMapIP2Tel = a,b,c,d,e,f,g,h,i
a = Destination number prefix.
b = Number of stripped digits from the left, or (if brackets are used) from the
right. A combination of both options is allowed.
c = String to add as prefix, or (if brackets are used) as suffix. A combination
of both options is allowed.
d = Number of remaining digits from the right.
e = Not applicable, set to $$.
f = Not applicable, set to $$.
g = Source number prefix.
h = Not applicable, set to $$.
i = Source IP address (obtained from the Contact header in the INVITE
message).
The ‘b’ to ‘d’ manipulation rules are applied if the called and calling numbers
match the ‘a’, ‘g’ and ‘i’ conditions.
The manipulation rules are executed in the following order: ‘b’, ‘d’ and ‘c’.
Parameters can be skipped by using the sign ‘$$’, for example:
NumberMapIP2Tel =01,2,972,$$,$$,$$,034,$$,10.13.77.8
NumberMapIP2Tel =03,(2),667,$$,$$,$$,22
Note: The Source IP address can include the ‘x’ wildcard to represent single
digits. For example: 10.8.8.xx represents all the addresses between 10.8.8.10
to 10.8.8.99. The ‘*’ wildcard represents any number between 0 and 255, e.g.
10.8.8.* represents all the addresses between 10.8.8.0 and 10.8.8.255.
SourceNumberMapTel2IP
SourceNumberMapTel2IP = a,b,c,d,e,f,g,h
a = Source number prefix
b = Number of stripped digits from the left, or (if in brackets are used) from
right. A combination of both options is allowed.
c = String to add as prefix, or (if in brackets are used) as suffix. A
combination of both options is allowed.
d = Number of remaining digits from the right
e = Number Plan used in RPID header
f = Number Type used in RPID header
g = Destination number prefix
h = Calling number presentation (0 to allow presentation, 1 to restrict
presentation)
The ‘b’ to ‘f’ and ‘h’ manipulation rules are applied if the called and calling
numbers match the ‘a’ and ‘g’ conditions.
The manipulation rules are executed in the following order: ‘b’, ‘d’ and ‘c’.
Parameters can be skipped by using the sign ‘$$’, for example:
SourceNumberMapTel2IP=01,2,972,$$,0,0,$$,1
SourceNumberMapTel2IP=03,(2),667,$$,0,0,22
Note 1: ‘Presentation’ is set to ‘Restricted’ only if ‘Asserted Identity Mode’ is
set to ‘P-Asserted’.
Note 2: Number Plan & Type can optionally be used in Remote Party ID
(RPID) header by using the ‘EnableRPIHeader’ parameter.