User`s manual

MediaPack
SIP User's Manual 82 Document #: LTRT-65408
Table 5-8: Advanced Parameters, General Parameters (continues on pages 78 to 82)
Parameter Description
Enable Calls Cut Through
[CutThrough]
Enables users to receive incoming IP calls while the port is in an offhooked
state.
Disable
[0] = Disabled (default).
Enable
[1] = Enabled.
If enabled, FXS gateways answer the call and ‘cut through’ the voice channel, if
there is no other active call on that port, even if the port is in offhooked state.
When the call is terminated (by the remote party), the gateway plays a reorder
tone for ‘TimeForReorderTone’ seconds and is then ready to answer the next
incoming call, without onhooking the phone.
The waiting call is automatically answered by the gateway when the current call
is terminated (EnableCallWaiting=1).
Note: This option is applicable only to FXS gateways.
EnableUserInfoUsage
[Enable User-Information
Usage]
Enables or disables usage of the User Information loaded to the gateway via the
User Information auxiliary file.
0 = Disable (default).
1 = Enable.
FXSOOSBehavior
[Out-Of-Service Behavior]
Determines the behavior of FXS endpoints that are not defined (in the Endpoint
Phone Number table), and the behavior of all FXS endpoints when a Busy-Out
condition exists.
0 (None) = Normal operation: No response is provided to undefined endpoints.
Dial tone is played to FXS endpoints when a Busy-Out condition exists.
1 (Reorder Tone) = The gateway plays a reorder tone to the connected
phone/PBX (default).
2 (Polarity Reversal) = The gateways reverses the polarity of the endpoint,
marking it as unusable (relevant, for example, to PBX DID lines). This option
can’t be configured on-the-fly.
3 (Polarity Reversal + Reorder Tone) = Same as 2 and 3 combined. This option
can’t be configured on-the-fly.