User`s manual

MediaPack
SIP User's Manual 74 Document #: LTRT-65408
5.5.1.4 DTMF & Dialing Parameters
Use this screen to configure parameters that are associated with DTMF and dialing.
¾
To configure the dialing parameters, take these 4 steps:
1. Open the ‘DTMF & Dialing’ screen (Protocol Management menu > Protocol
Definition submenu > DTMF & Dialing option); the ‘DTMF & Dialing’ screen is
displayed.
Figure 5-8: DTMF & Dialing Screen
2. Configure the DTMF & Dialing parameters according to Table 5-7.
3. Click the Submit button to save your changes.
4. To save the changes so they are available after a power fail, refer to Section 5.10.2 on
page 205.
Table 5-7: DTMF & Dialing Parameters (continues on pages 74 to 76)
Parameter Description
Max Digits in Phone Num
[MaxDigits]
Note: Digit Mapping Rules
can be used instead.
Maximum number of digits that can be dialed.
The valid range is 1 to 49.
The default value is 5.
Note: Dialing ends when the maximum number of digits is dialed, the Interdigit
Timeout expires, the '#' key is dialed, or a digit map pattern is matched.
Inter Digits Timeout for
Overlap Dialing [sec]
[TimeBetweenDigits]
Time in seconds that the gateway waits between digits dialed by the user. When
the Interdigit Timeout expires, the gateway attempts to dial the digits already
received.
The valid range is 1 to 10 seconds. The default value is 4 seconds.