User`s manual

SIP User's Manual 4. Getting Started
Version 5.0 47 December 2006
5. Configure ‘Enable Registration’ to ‘Yes’ or ‘No’:
• ‘No’ = the MediaPack does not register to a Proxy server/Registrar (default).
• ‘Yes’ = the MediaPack registers to a Proxy server/Registrar at power up and
every ‘Registration Time’ seconds; The MediaPack sends a REGISTER request
according to the ‘Authentication Mode’ parameter. For detailed information on the
parameters ‘Registration Time’ and ‘Authentication Mode’, refer to Table 5-4 on
page 66
.
6. To configure the Coders Table, click the arrow button next to ‘Coders Table’. For
information on how to configure the Coders Table, refer to Section 5.5.1.3 on page 72.
7. To configure the Tel to IP Routing Table, click the arrow button next to ‘Tel to IP
Routing Table’. For information on how to configure the Tel to IP Routing Table, refer
to Section 5.5.5.2 on page 100.
8. To configure the Endpoint Phone Number Table, click the arrow button next to
‘Endpoint Phone Number’. For information on how to configure the Endpoint Phone
Number Table, refer to Section 5.5.7 on page 115.
9. Click the Reset button, and then at the prompt, click OK; the MediaPack applies the
changes and restarts.
You are now ready to start using the VoIP gateway. To prevent unauthorized access to the
MediaPack, it is recommended that you change the username and password that are used
to access the Web Interface. Refer to Section 5.6.5.1 on page 168 for details on how to
change the username and password.
Tip: Once the gateway is configured correctly back up your settings by
making a copy of the VoIP gateway configuration (ini file) and store it in
a directory on your PC. This saved file can be used to restore
configuration settings at a future time. For information on backing up
and restoring the gateway’s configuration, refer to Section 5.6.3 on
page 165.