User`s manual

SIP User's Manual F. SNMP Traps
Version 5.0 377 December 2006
Table F-4: acOperationalStateChange Alarm Trap
Alarm:
acOperationalStateChange
OID:
1.3.6.1.4.1.5003.9.10.1.21.2.0.15
Default Severity
Major
Event Type:
processingErrorAlarm
Probable Cause:
outOfService (71)
Alarm Text:
Network element operational state change alarm. Operational state is disabled.
Note:
This alarm is raised if the operational state of the node goes to disabled. The
alarm is cleared when the operational state of the node goes to enabled. In IP
systems, the operational state of the node is disabled if the device fails to
properly initialize.
Status Changes:
Condition:
Operational state changed to disabled
Alarm status: Major
Condition:
Operational state changed to enabled
Alarm status: Cleared
Corrective Action:
In IP systems, check for initialization errors. Look for other alarms and Syslogs
that might provide additional information about the error.
Table F-5: acBoardEvResettingBoard Alarm Trap
Alarm:
acBoardEvResettingBoard
OID:
1.3.6.1.4.1.5003.9.10.1.21.2.0.5
Default Severity:
critical
Event Type:
equipmentAlarm
Probable Cause:
outOfService (71)
Alarm Text:
User resetting board
Status Changes:
Condition:
When a soft reset is triggered via the Web interface or SNMP.
Alarm status:
Critical
Condition:
After raise
Alarm status:
Status stays critical until reboot. A clear trap is not sent.
Corrective Action:
A network administrator has taken action to reset the device. No corrective action
is required.