User`s manual

SIP User's Manual E. Accessory Programs and Tools
Version 5.0 369 December 2006
E.2.4 Recording Screen – Automatic Mode
After the connection to the MediaPack/FXO gateway is established, the recording screen is
displayed.
Figure E-7: Recording Screen –Automatic Mode
¾
To start recording in automatic mode, take these 3 steps:
1. Click the Start Automatic Configuration button; the wizard starts the following Call
Progress Tones detection sequence (the operation takes approximately 60 seconds to
complete):
• Sets port 1 offhook, listens to the dial tone.
• Sets port 1 and port 2 offhook, dials the number of port 2, listens to the busy tone.
• Sets port 1 offhook, dials the number of port 2, listens to the Ringback tone.
• Sets port 1 offhook, dials an invalid number, listens to the reorder tone.