User`s manual

MediaPack
SIP User's Manual 368 Document #: LTRT-65408
E.2.2 Installation
The CPTWizard can be installed on any Windows 2000 or Windows XP based PC.
Windows-compliant networking and audio peripherals are required for full functionality.
To install the CPTWizard, copy the files from the supplied installation kit to any folder on
your PC. No further setup is required (approximately 5 MB of hard disk space are
required).
E.2.3 Initial Settings
¾ To start the CPTWizard, take these 5 steps:
1. Execute the CPTWizard.exe file; the wizard’s initial settings screen is displayed.
Figure E-6: Initial Settings Screen
2. Enter the IP address of the MediaPack/FXO gateway you are using.
3. Select the gateway’s ports that are connected to your PBX, and specify the phone
number of each extension.
4. In the 'Invalid phone number' field, enter a number that generates a ‘fast busy’ tone
when dialed. Usually, any incorrect phone number should cause a ‘fast busy’ tone.
5. Click Next.
Note: The CPTWizard communicates with the FXO gateway via TPNCP
(TrunkPack Network Control Protocol). If this protocol has been
disabled in the gateway configuration, the CPTWizard doesn’t display
the next screen and an error is reported.