User`s manual

MediaPack
SIP User's Manual 318 Document #: LTRT-65408
14.8.3.1 Configuration of Trusted Managers via ini File
To set the Trusted Mangers table from start-up, write the following in the ini file:
SNMPTRUSTEDMGR_X = D.D.D.D
where X is any integer between 0 and 4 (0 sets the first table entry, 1 sets the second, and
so on), and D is an integer between 0 and 255.
14.8.3.2 Configuration of Trusted Managers via SNMP
To configure Trusted Managers, the EM must use the SNMP-COMMUNITY-MIB, the
snmpTargetMIB and the TGT-ADDRESS-MASK-MIB.
¾
To add the first Trusted Manager, take these 3 steps:
(The following procedure assumes that there is at least one configured read-write
community. There are currently no Trusted Managers. The taglist for columns for all
srCommunityTable rows are currently empty).
1. Add a row to the snmpTargetAddrTable with these values: Name=mgr0,
TagList=MGR, Params=v2cparams.
2. Add a row to the tgtAddressMaskTable table with these values: Name=mgr0,
tgtAddressMask=255.255.255.255:0. The agent doesn’t allow creation of a row in this
table unless a corresponding row exists in the snmpTargetAddrTable.
3. Set the value of the TransportLabel field on each non-TrapGroup row in the
srCommunityTable to MGR.
The following procedure assumes that there is at least one configured read-write
community. There are currently one or more Trusted Managers. The taglist for columns for
all rows in the srCommunityTable are currently set to MGR. This procedure must be
performed from one of the existing Trusted Managers.
¾
To add a subsequent Trusted Manager, take these 2 steps:
1. Add a row to the snmpTargetAddrTable with these values: Name=mgrN,
TagList=MGR, Params=v2cparams, where N is an unused number between 0 and 4.
2. Add a row to the tgtAddressMaskTable table with these values: Name=mgrN,
tgtAddressMask=255.255.255.255:0.
An alternative to the above procedure is to set the tgtAddressMask column while you
are creating other rows in the table.
The following procedure assumes that there is at least one configured read-write
community. There are currently two or more Trusted Managers. The taglist for columns for
all rows in the srCommunityTable are currently set to MGR. This procedure must be
performed from one of the existing trusted managers, but not the one that is being deleted.
¾
To delete a Trusted Manager (not the final one), take this step:
 Remove the appropriate row from the snmpTargetAddrTable.
The change takes effect immediately. The deleted trusted manager cannot access the
device. The agent automatically removes the row in the tgtAddressMaskTable.