User`s manual

MediaPack
SIP User's Manual 310 Document #: LTRT-65408
 RTCP-XR: This MIB (RFC) implements the following partial support:
• The rtcpXrCallQualityTable is fully supported.
• In the rtcpXrHistoryTable, support of the RCQ objects is provided only with no
more than 3 intervals, 15 minutes long each.
• Supports the rtcpXrVoipThresholdViolation trap.
In addition to the standard MIBs, the complete product series contains proprietary MIBs:
 AC-TYPES MIB: lists the known types defined by the complete product series. This is
referred to by the sysObjectID object in the MIB-II.
Note: The acBoard MIB is still supported, but is being replaced by five newer
proprietary MIBs.
As noted above, five new MIBs cover the device’s general parameters. Each contains
a Configuration subtree for configuring related parameters. In some, there also are
Status and Action subtrees.
The 5 MIBs are:
• AC-ANALOG-MIB
• AC-CONTROL-MIB
• AC-MEDIA-MIB
• AC-PSTN-MIB
• AC-SYSTEM-MIB
Other proprietary MIBs are:
 acGateway MIB: This proprietary MIB contains objects related to configuration of the
device when applied as a SIP or H.323 media gateway only. This MIB complements
the other proprietary MIBs.
The acGateway MIB has the following groups:
• Common - for parameters common to both SIP and H.323
• SIP - for SIP parameters only
• H.323 - for H.323 parameters only
 acAlarm: This is a proprietary carrier-grade alarm MIB. It is a simpler implementation
of the notificationLogMIB and the IETF suggested alarmMIB (both also supported in all
MediaPack and related devices).
The acAlarm MIB has the following groups:
• ActiveAlarm - straightforward (single-indexed) table, listing all currently active
alarms, together with their bindings (the alarm bindings are defined in acAlarm.
acAlarmVarbinds and also in acBoard.acTrap. acBoardTrapDefinitions.
oid_1_3_6_1_4_1_5003_9_10_1_21_2_0).
• acAlarmHistory - straightforward (single-indexed) table, listing all recently raised
alarms together with their bindings (the alarm bindings are defined in acAlarm.
acAlarmVarbinds and also in acBoard.acTrap. acBoardTrapDefinitions.
oid_1_3_6_1_4_1_5003_9_10_1_21_2_0).
The table size can be altered via
notificationLogMIB.notificationLogMIBObjects.nlmConfig.nlmConfigGlobalEntryLimit or
notificationLogMIB.notificationLogMIBObjects.nlmConfig.nlmConfigLogTable.nlm
ConfigLogEntry.nlmConfigLogEntryLimit.
The table size can be any value from 10 to 100 and is 100 by default.