User`s manual

SIP User's Manual 3. Installing the MediaPack
Version 5.0 31 December 2006
Table 3-1: View of the MP-11x Base
Item # Functionality
1 Square slot used to attach anti-slide bumpers (for desktop mounting)
2 Oval notch used to attach the MP-11x to a wall
3 Screw opening used to attach the MP-11x to a 19-inch shelf rack
3.1.4.1 Mounting the MP-11x on a Desktop
Attach the four (supplied) anti-slide bumpers to the base of the MP-11x (refer to item #1 in
Figure 3-2) and place it on the desktop in the position you require.
3.1.4.2 Mounting the MP-11x on a Wall
¾ To mount the MP-11x on a wall, take these 4 steps:
1. Drill four holes according to the following dimensions:
• Side-to-side distance 140 mm.
• Front-to-back distance 101.4 mm.
2. Insert a wall anchor of the appropriate size into each hole.
3. Fasten a DIN 96 3.5X20 wood screw (not supplied) into each of the wall anchors.
4. Position the four oval notches located on the base of the MP-11x (refer to item #2 in
Figure 3-2) over the four screws and hang the MP-11x on them.