User`s manual

SIP User's Manual 3. Installing the MediaPack
Version 5.0 29 December 2006
3 Installing the MediaPack
This section provides information on the installation procedure for the MP-11x (refer to
Section 3.1 below) and the MP-124 (refer to Section 3.2 on page 36). For information on
how to start using the gateway, refer to Chapter 4 on page 41.
Caution Electrical Shock
The equipment must only be installed or serviced by qualified service
personnel
3.1 Installing the MP-11x
¾ To install the MP-11x, take these 4 steps:
1. Unpack the MP-11x (refer to Section 3.1.1).
2. Check the package contents (refer to Section 3.1.2).
3. Mount the MP-11x (refer to Section 3.1.4 on page 30).
4. Cable the MP-11x (refer to Section 3.1.5 on page 38).
After connecting the MP-11x to the power source, the Ready and Power LEDs on the front
panel turn to green (after a self-testing period of about two minutes). Any malfunction in the
startup procedure changes the Fail LED to red and the Ready LED is turned off (refer to
Table 2-1 on page 26 for details on the MP-11x LEDs).
When you have completed the above relevant sections you are then ready to start
configuring the gateway (Chapter 5 on page 49).
3.1.1 Unpacking
¾ To unpack the MP-11x, take these 6 steps:
1. Open the carton and remove the packing materials.
2. Remove the MP-11x gateway from the carton.
3. Check that there is no equipment damage.
4. Check, retain and process any documents.
5. Notify AudioCodes or your local supplier of any damage or discrepancies.
6. Retain any diskettes or CDs.
3.1.2 Package Contents
Ensure that in addition to the MP-11x, the package contains:
 AC power cable.
 Small plastic bag containing four anti-slide bumpers for desktop installation.
 A CD with software and documentation may be included.
 The MediaPack Fast Track Installation Guide.