User`s manual

MediaPack
SIP User's Manual 274 Document #: LTRT-65408
10.6.2 Replacing the Background Image File
The background image file is duplicated across the width of the screen. The number of
times the image is duplicated depends on the width of the background image and screen
resolution. When choosing your background image, keep this in mind.
Note: Use a gif, jpg or jpeg file for the background image. It is important that
the image file has a fixed height of 59 pixels. The size of the image files
(logo and background) is limited each to 64 kbytes.
¾ To replace the background image via the Web, take these 6 steps:
1. Access the MediaPack Embedded Web Server (refer to Section 5.3 on page 51).
2. In the URL field, append the suffix ‘AdminPage’ (note that it’s case-sensitive) to the IP
address, e.g., http://10.1.229.17/AdminPage.
3. Click the Image Load to Device, the Image load screen is displayed (shown in Figure
10-7).
4. Click the Browse button in the 'Send Background Image File from your computer to
gateway' box. Navigate to the folder that contains the background image file you want
to load.
5. Click the Send File button; the file is sent to the device. When loading is complete, the
screen is automatically refreshed and the new background image is displayed.
6. To save the image to flash memory so it is available after a power fail, refer to Section
5.10.2 on page 205.
The new background appears on all Web Interface screens.
Tip 1: If you encounter any problem during the loading of the files, or you
want to restore the default images, click the Restore Default Images
button.
Tip 2: When replacing both the background image and the logo image, first
load the logo image followed by the background image.
¾ To replace the background image via the ini file, take these 2
steps:
1. Place your background image file in the same folder as where the device’s ini file is
located (i.e., the same location defined in the BootP/TFTP configuration utility). For
detailed information on the BootP/TFTP, refer to Appendix C on page 349.
2. Add/modify the ini file parameters in Table 10-5 according to the procedure described
in Section 6.2 on page 209.
Note that loading the device’s ini file via the ‘Configuration File’ screen in the Web Interface
doesn’t load the logo image file as well.
Table 10-5: Customizable Logo ini File Parameters
Parameter Description
BkgImageFileName The name (and path) of the file containing the new background.
Use a gif, jpg or jpeg image file.
The default is AudioCodes background file.
Note: The length of the name of the image file is limited to 47 characters.