User`s manual
SIP User's Manual 10. Advanced System Capabilities
Version 5.0 261 December 2006
10 Advanced System Capabilities
10.1 Restoring Networking Parameters to their Initial
State
You can use the ‘Reset’ button to restore the MediaPack networking parameters to their
factory default values (described in Table 4-1) and to reset the username and password.
Note that the MediaPack returns to the software version burned in flash. This process also
restores the MediaPack parameters to their factory settings. Therefore, you must load your
previously backed-up ini file, or the default ini file (received with the software kit) to set
them to their correct values.
¾
To restore the networking parameters of the MP-11x to their initial
state, take these 4 steps:
1. Press in the ‘Reset’ button uninterruptedly for a duration of more than six seconds; the
gateway is restored to its factory settings (username: ‘Admin’, password: ‘Admin’).
2. Assign the MP-11x IP address (refer to Section 4.2 on page 41).
3. Load your previously backed-up ini file, or the default ini file (received with the
software kit). To load the ini file via the Embedded Web Server, refer to Section 5.6.3
on page 165.
4. Press again on the ‘Reset’ button (this time for a short period).
¾ To restore the networking parameters of the MP-124 to their initial
state, take these 6 steps:
1. Disconnect the MP-124 from the power and network cables.
2. Reconnect the power cable; the gateway is powered up. After approximately 45
seconds the Ready LED turns to green and the Control LED blinks for about 3
seconds.
3. While the Control LED is blinking, press shortly on the reset button (located on the left
side of the front panel); the gateway resets a second time and is restored with factory
default parameters (username: ‘Admin’, password: ‘Admin’).
4. Reconnect the network cable.
5. Assign the MP-124 IP address (refer to Section 4.2 on page 41).
6. Load your previously backed-up ini file, or the default ini file (received with the
software kit). To load the ini file via the Embedded Web Server, refer to Section 5.6.3
on page 165.