User`s manual

SIP User's Manual 8. Telephony Capabilities
Version 5.0 245 December 2006
3. In the ‘Tel to IP Routing’ screen, enter 20 in the ‘Destination Phone Prefix’ field, and
the IP address of the FXO MediaPack gateway (10.1.10.2) in the field ‘IP Address’.
Note: In remote extensions, for the transfer to function, hold must be disabled
on the FXS (i.e., Enable Hold = 0).
8.12.4.4 FXO MediaPack Configuration (using the Embedded Web Server)
¾ To configure the FXO MediaPack, take these 4 steps:
1. In the ‘Endpoint Phone Numbers’ screen, assign the phone numbers 200 to 207 for
the gateway’s endpoints.
2. In the ‘Automatic Dialing’ screen, enter the phone numbers of the FXS MediaPack
gateway in the ‘Destination Phone Number’ fields. When a ringing signal is detected at
port #1, the FXO gateway automatically dials the number ‘100’.
3. In the ‘Tel to IP Routing’ screen, enter 10 in the ‘Destination Phone Prefix’ field, and
the IP address of the FXS MediaPack gateway (10.1.10.3) in the field ‘IP Address’.
4. In the ‘Protocol Management’ screen, set the parameter ‘
Dialing Mode’ to ‘Two Stage’
(
IsTwoStageDial=1).