User`s manual

MediaPack
SIP User's Manual 244 Document #: LTRT-65408
8.12.4.2 Dialing from other PBX line, or from PSTN
¾ To configure the call, take these 5 steps:
1. Dial the PBX subscriber number the same way as if the user’s phone was connected
directly to PBX.
2. When the PBX rings the FXO MediaPack, the ring signal is immediately ‘sent' to the
phone connected to the FXS MediaPack.
3. Once the phone’s handset, connected to the FXS MediaPack is raised, the FXO
MediaPack seizes the PBX line and the voice path is established between the phone
and the PBX line.
4. There is a one-to-one mapping between PBX lines and FXS MediaPack ports. Each
PBX line is routed to the same phone (connected to the FXS MediaPack).
5. The call is disconnected when the phone connected to FXS MediaPack goes onhook.
8.12.4.3 FXS MediaPack Configuration (using the Embedded Web Server)
¾ To configure the FXS MediaPack, take these 3 steps:
1. In the ‘Endpoint Phone Numbers’ screen, assign the phone numbers 100 to 107 for
the gateway’s endpoints.
2. In the ‘Automatic Dialing’ screen, enter the phone numbers of the FXO MediaPack
gateway in the ‘Destination Phone Number’ fields. When a phone connected to port #1
goes offhook, the FXS gateway automatically dials the number ‘200’.