User`s manual

MediaPack
SIP User's Manual 214 Document #: LTRT-65408
7.3.2 Vendor Specific Information Field
The MediaPack uses the vendor specific information field in the BootP request to provide
device-related initial startup information. The BootP/TFTP configuration utility displays this
information in the ‘Client Info’ column (refer to Figure C-1).
Note: This option is not available on DHCP servers.
The Vendor Specific Information field is disabled by default. To enable / disable this
feature: set the ini file parameter ‘ExtBootPReqEnable’ (Table 5-55 on page 182) or use
the ‘-be’ command line switch (refer to Table C-1 on page 359).
Table 7-1 details the vendor specific information field according to device types:
Table 7-1: Vendor Specific Information Field
Tag #
Description Value Length
220
Gateway Type #13 = MP-124
#14 = MP-118
#15 = MP-114
#16 = MP-112
1
221
Current IP Address XXX.XXX.XXX.XXX 4
222
Burned Boot Software Version X.XX 4
223
Burned cmp Software Version XXXXXXXXXXXX 12
224
Geographical Address 0 – 31 1
225
Chassis Geographical Address 0 – 31 1
228
Indoor / Outdoor
(Indoor is valid only for FXS.
FXO is always Outdoor.)
#0 = Indoor
#1 = Outdoor
1
229
E&M N/A 1
230
Analog Channels 2 / 4 / 8 / 24 1
Table 7-2 exemplifies the structure of the vendor specific information field for a TP-1610
slave module with IP address 10.2.70.1.
Table 7-2: Structure of the Vendor Specific Information Field
Vendor-
Specific
Informati
on Code
Length
Total
Tag Num
Length
Value
Tab Num
Length
Value
Tag Num
Length
Value (1) Value (2) Value (3) Value (4)
Tag End
42 12 220 1 2 225 1 1 221 4 10 2 70 1 255