User`s manual

MediaPack
SIP User's Manual 198 Document #: LTRT-65408
¾ To use the Software Upgrade Wizard, take these 11 steps:
1. Stop all traffic on the MediaPack (refer to the note above).
2. Open the ‘Software Upgrade Wizard’ (Software Update menu > Software Upgrade
Wizard); the ‘Start Software Upgrade’ screen appears.
Figure 5-63: Start Software Upgrade Screen
Note: At this point, the process can be canceled with no consequence to the
MediaPack (click the Cancel button). If you continue the process (by
clicking the Start Software Upgrade button, the process must be
followed through and completed with a MediaPack reset at the end. If
you click the Cancel button in any of the subsequent screens, the
MediaPack is automatically reset with the configuration that was
previously burned in flash memory.
3. Click the Start Software Upgrade button; the ‘Load a cmp file’ screen appears
(Figure 5-64).
Note: When in the Wizard process, the rest of the Web application is
unavailable and the background Web screen is disabled. After the
process is completed, access to the full Web application is restored.