User`s manual

SIP User's Manual 5. Web Management
Version 5.0 177 December 2006
Table 5-51: Management Settings Parameters (continues on pages 177 to 178)
Parameter Description
Syslog Settings
Syslog Server IP address
[SyslogServerIP]
IP address (in dotted format notation) of the computer you are using to run
the Syslog Server.
The Syslog Server is an application designed to collect the logs and error
messages generated by the VoIP gateway.
For information on the Syslog, refer to Section
13.2 on page 301.
Syslog Server Port
[SyslogServerPort]
Defines the UDP port of the Syslog server.
The default value (i.e., port) is 514.
Enable Syslog
[EnableSyslog]
Enable
[1] = Send the logs and error message generated by the gateway to
the Syslog Server. If you select Enable, you must enter an IP address in the
Syslog Server IP address field.
Disable
[0] = Logs and errors are not sent to the Syslog Server (default).
Note 1: Syslog messages may increase the network traffic.
Note 2: Logs are also sent to the RS-232 serial port (for information on
establishing a serial communications link with the MediaPack, refer to
Section 10.2 on page 262).
Note 3: To configure the Syslog logging levels use the parameter ‘Debug
Level’.
SNMP Settings
For detailed information on the SNMP parameters that can only be configured via the ini file, refer to Table 5-57
on page 186.
For detailed information on developing an SNMP-based program to manage your devices, refer to Chapter
14
on page 305.
SNMP Managers Table
Refer to Section
5.6.6.1 on page 178.
SNMP Community Strings
Refer to Section
5.6.6.2 on page 180.
SNMP V3 Table
Refer to Section
5.6.6.3 on page 181.
Enable SNMP
[DisableSNMP]
Enable
[0] = SNMP is enabled (default).
Disable
[1] = SNMP is disabled and no traps are sent.
Trap Manager Host Name
[SNMPTrapManagerHostName]
Defines a FQDN of a remote host that is used as an SNMP Manager. The
resolved IP address replaces the last entry in the trap manager table
(defined by the parameter ‘SNMPManagerTableIP_x’) and the last trap
manager entry of snmpTargetAddrTable in the snmpTargetMIB.
For example: 'mngr.corp.mycompany.com'.
The valid range is a 99-character string
Activity Types to Report via 'Activity Log' Messages
The Activity Log mechanism enables the MediaPack to send log messages (to a Syslog server) that report
certain types of Web actions according to a pre-defined filter.
The following filters are available:
Parameters Value Change
[ActivityListToLog = PVC]
Changes made on-the-fly to parameters.
Auxiliary Files Loading
[ActivityListToLog = AFL]
Loading of auxiliary files (e.g., via Certificate screen).
Device Reset
[ActivityListToLog = DR]
Device reset via the 'Maintenance Actions' screen.
Flash Memory Burning
[ActivityListToLog = FB]
Burning of files / parameters to flash (e.g., 'Maintenance Actions' screen).
Device Software Update
[ActivityListToLog = SWU]
cmp loading via the Software Upgrade Wizard.