User`s manual

SIP User's Manual 5. Web Management
Version 5.0 167 December 2006
¾ To load a configuration file to the gateway, take these 8 steps:
1. Open the ‘Regional Settings’ screen (Advanced Configuration menu > Regional
Settings); the ‘Regional Settings’ screen is displayed (shown in Figure 5-46).
2. Click the Browse button adjacent to the file you want to load.
3. Navigate to the folder that contains the file you want to load.
4. Click the file and click the Open button; the name and path of the file appear in the
field beside the Browse button.
5. Click the Send File button that is next to the field that contains the name of the file you
want to load. An exclamation mark in the screen section indicates that the file’s
loading doesn’t take effect on-the-fly (e.g., CPT file).
6. Repeat steps 2 to 5 for each file you want to load.
Notes:
• Saving a configuration file to flash memory may disrupt traffic on the
MediaPack. To avoid this, disable all traffic on the device before
saving to flash memory by performing a graceful lock (refer to
Section 5.10.1 on page 204).
• A device reset is required to activate a loaded CPT file.
7. To save the loaded auxiliary files so they are available after a power fail, refer to
Section 5.10.2 on page 205.
8. To reset the MediaPack, refer to Section 5.10.3 on page 206.