User`s manual

SIP User's Manual 5. Web Management
Version 5.0 155 December 2006
Table 5-43: Media Settings, Fax/Modem/CID Parameters (continues on pages 154 to 157)
Parameter Description
Caller ID Type
[CallerIDType]
Defines one of the following standards for detection (FXO) and generation
(FXS) of Caller ID and detection (FXO) of MWI (when specified) signals.
Bellcore
[0] (Caller ID and MWI) (default).
ETSI
[1] (Caller ID and MWI)
NTT
[2].
Backward Compatible
[3]
British
[4]
DTMF ETSI
[16]
Denmark
[17] (Caller ID and MWI)
India
[18]
Brazil
[19]
Note 1: The Caller ID signals are generated/detected between the first and
the second rings.
Note 2: To select the Bellcore Caller ID sub standard, use the parameter
‘BellcoreCallerIDTypeOneSubStandard’. To select the ETSI Caller ID sub
standard, use the parameter ‘ETSICallerIDTypeOneSubStandard’.
Note 3: To select the Bellcore MWI sub standard, use the parameter
‘BellcoreVMWITypeOneStandard’. To select the ETSI MWI sub standard,
use the parameter ‘ETSIVMWITypeOneStandard’.
Note 4: If you define NTT (i.e., 2) for the caller ID type, you need to define
the NTT DID signaling form (FSK or DTMF) using NTTDIDSignallingForm.
V.21 Modem Transport Type
[V21ModemTransportType]
V.21 Modem Transport Type that the gateway uses.
You can select:
[0] = Disable (Transparent) -- default
[1] = Enable Relay – N/A
[2] = Enable Bypass
3 = Events Only (Transparent with Events)
V.22 Modem Transport Type
[V22ModemTransportType]
V.22 Modem Transport Type that the gateway uses.
You can select:
[0] = Disable (Transparent)
[1] = Enable Relay -- N/A
[2] = Enable Bypass -- default
[3] = Events Only (Transparent with Events)
V.23 Modem Transport Type
[V23ModemTransportType]
V.23 Modem Transport Type that the gateway uses.
You can select:
[0] = Disable (Transparent)
[1] = Enable Relay -- N/A
[2] = Enable Bypass -- default
[3] = Events Only (Transparent with Events)
V.32 Modem Transport Type
[V32ModemTransportType]
V.32 Modem Transport Type that the gateway uses.
You can select:
[0] = Disable (Transparent)
[1] = Enable Relay -- N/A
[2] = Enable Bypass -- default
[3] = Events Only (Transparent with Events)
Note: This option applies to V.32 and V.32bis modems.
V.34 Modem Transport Type
[V34ModemTransportType]
V.90 / V.34 Modem Transport Type that the gateway uses.
You can select:
[0] = Disable (Transparent)
[1] = Enable Relay -- N/A
[2] = Enable Bypass -- default
[3] = Events Only (Transparent with Events)
Fax Relay Redundancy Depth
[FaxRelayRedundancyDepth]
Number of times that each fax relay payload is retransmitted to the network.
The valid range is 0 to 2.
The default value is 0.