User`s manual

MediaPack
SIP User's Manual 154 Document #: LTRT-65408
5.6.2.2 Configuring the Fax / Modem / CID Settings
¾ To configure the Fax / Modem / CID Settings parameters, take
these 4 steps:
1. Open the ‘Fax / Modem / CID Settings’ screen (Advanced Configuration menu >
Media Settings > Fax / Modem / CID Settings option); the ‘Fax / Modem / CID
Settings’ screen is displayed.
Figure 5-41: Fax / Modem / CID Settings Screen
2. Configure the Fax / Modem / CID Settings according to Table 5-43.
3. Click the Submit button to save your changes.
4. To save the changes so they are available after a power fail, refer to Section 5.10.2 on
page 205.
Table 5-43: Media Settings, Fax/Modem/CID Parameters (continues on pages 154 to 157)
Parameter Description
Fax Transport Mode
[FaxTransportMode]
Fax Transport Mode that the gateway uses.
You can select:
Disable
[0] (transparent mode).
T.38 Relay
[1] (default).
Bypass
[2].
Events Only
[3].
Note: If parameter IsFaxUsed = 1, then FaxTransportMode is always set to
1 (T.38 relay).
Caller ID Transport Type
[CallerIDTransportType]
N/A.