User`s manual

MediaPack
SIP User's Manual 144 Document #: LTRT-65408
¾ To delete a remote NFS file system, take these 3 steps:
1. Select the 'Edit' radio button for the row to be deleted.
2. Click the Delete Line button; the row is deleted.
3. To save the changes so they are available after a power fail, refer to Section 5.10.2 on
page 205.
¾ To modify an existing remote NFS file system, take these 4 steps:
1. Select the 'Edit' radio button for the row to be modified.
2. Change the values on the selected row according to your requirements.
3. Click the Apply New Settings button; the remote NFS file system is mounted using
the new settings. Check the Syslog server for the ‘NFS mount was successful’
message.
4. To save the changes so they are available after a power fail, refer to Section 5.10.2 on
page 205.
Table 5-38: Network Settings, NFS Settings Parameters
Parameter Description
Line Number
[NFSServers_Index]
The row index of the remote file system.
The valid range is 0 to 4.
Host / IP
[NFSServers_HostOrIP]
The domain name or IP address of the NFS server. If a domain name
is provided, a DNS server must be configured.
Root Path
[NFSServers_RootPath]
Path to the root of the remote file system.
In the format: ‘/’ + [path]
For example, /audio
The combination of Host / IP and Root Path must be unique for each row in the table. For example, there must
be only one row in the table with a Host / IP of 192.168.1.1 and Root Path of /audio.
NFS Version
[NFSServers_NfsVersion]
NFS version to use with the remote file system, 2 or 3 (default).
Auth Type
[NFSServers_AuthType]
Identifies the authentication method used with the remote file system.
AUTH_NULL
[0].
AUTH_UNIX [1] (default).
UID
[NFSServers_UID]
User ID used in authentication if using AUTH_UNIX.
The valid range is 0 to 65537. The default is 0.
GID
[NFSServers_GID]
Group ID used in authentication if using AUTH_UNIX.
The valid range is 0 to 65537. The default is 1
VLAN Type
[NFSServers_VlanType]
The VLAN, OAM [0] or Media [1], to use when accessing the remote
file system. The default is to use the media VLAN.
This parameter applies only if VLANs are enabled or if Multiple IPs is
configured (refer to Section
9.8 on page 253).
Figure 5-38 below shows an example of an NFS table definition via ini file using parameter
tables (for information on parameter tables, refer to Section 10.5 on page 267).
Figure 5-38: NFS ini File Example
[ NFSServers ]
FORMAT NFSServers_Index = NFSServers_HostOrIP, NFSServers_RootPath,
NFSServers_NfsVersion, NFSServers_AuthType, NFSServers_UID, NFSServers_GID,
NFSServers_VlanType;
NFSServers 1 = 101.1.13, /audio1, 3, 1, 0, 1, 1;
[ \NFSServers ]