User`s manual

MediaPack
SIP User's Manual 132 Document #: LTRT-65408
5.5.13 Protocol Management ini File Parameters
Table 5-35 describes the SIP Protocol Management parameters that can only be
configured via the ini file.
Table 5-35: Protocol Management, ini File Parameters (continues on pages 132 to 137)
ini File Parameter
Name
Valid Range and Description
EnablePtime
0 = Remove the ptime header from SDP.
1 = Include the ptime header in SDP (default).
IsUseToHeaderAsCalled
Number
0 = Sets the destination number to the user part of the Request-URI for IPÆTel
calls, and sets the ‘Contact’ header to the source number for TelÆ IP calls
(default).
1 = Sets the destination number to the user part of the ‘To’ header for IPÆTel calls,
and sets the ‘Contact’ header to the username parameter for TelÆIP calls.
SIPSRequireClientCertifi
cate
0 = The gateway doesn’t require client certificate (default).
1 = The gateway (when acting as a server for the TLS connection) requires
reception of client certificate to establish the TLS connection.
Note: The SIPS certificate files can be changed using the parameters
‘HTTPSCertFileName’ and ‘HTTPSRootFileName’.
Send180ForCallWaiting
0 = Use 182 Queued response to indicate a call waiting (default).
1 = Use 180 Ringing response to indicate a call waiting.
NumberOfActiveDialogs
Defines the maximum number of active SIP dialogs that are not call related (i.e.,
REGISTER and SUBSCRIBE).
The valid range is 1 to 5. The default value is 5.
EnableDID
Enables Japan NTT ‘Modem’ Direct Inward Dialing (DID) support. FXS gateways
can be connected to Japan’s NTT PBX using ‘Modem’ DID lines. These DID lines
are used to deliver a called number to the PBX (applicable to FXS gateways). The
DID signal can be sent alone or combined with an NTT Caller ID signal.
EnableDID_X
Enables generation of Japan NTT Modem DID signal per port.
The format is: EnableDID_<Port> = <Modem DID>
Modem DID:
0 = Disabled (default).
1 = Enabled.
If not configured, use the global parameter ‘EnableDID’.
Note: Applicable only to MediaPack/FXS gateways.
NTTDIDSignallingForm
Determines the type of Direct Inward Dialing (DID) signaling support for Japan NTT
modem: DTMF- or Frequency Shift Keying (FSK)-based signaling. Gateways can
be connected to Japan’s NTT PBX using ‘Modem’ DID lines. These DID lines are
used to deliver a called number to the PBX.
0 = FSK-based signaling (default).
1 = DTMF-based signaling.
Note: Applicable only to FXS gateways.
FarEndDisconnectSilen
ceThreshold
Threshold of the packet count (in percents), below which is considered silence by
the media gateway.
The valid range is 1 to 100. The default is 8%.
Note: Applicable only if silence is detected according to packet count
(FarEndDisconnectSilenceMethod = 1).
T38UseRTPPort
Defines that the T.38 packets are sent / received using the same port as RTP
packets.
0 = Use the RTP port +2 to send / receive T.38 packets (default).
1 = Use the same port as the RTP port to send / receive T.38 packets.