User`s manual

MediaPack
SIP User's Manual 130 Document #: LTRT-65408
5.5.12 Configuring Voice Mail (VM) Parameters
Use this screen to configure the VM parameters. The VM application applies only to FXO
gateways. For detailed information on VM, refer to the CPE Configuration Guide for Voice
Mail.
¾
To configure the VM parameters, take these 4 steps:
1. Open the ‘Voice Mail’ screen (Protocol Management menu > FXO Settings > Voice
Mail option); the ‘Voice Mail’ screen is displayed.
Figure 5-34: Voice Mail Screen
2. Configure the Voice Mail parameters according to Table 5-34.
3. Click the Submit button to save your changes.
4. To save the changes so they are available after a power fail, refer to Section 5.10.2 on
page 205.
Table 5-34: Voice Mail Parameters ((continues on pages
130 to 131)
Parameter Description
General
Voice Mail Interface
[VoiceMailInterface]
Enables the voice mail (VM) application on the gateway and determines the
communication method used between the PBX and the gateway.
Valid options include:
None (default)
[0]
DTMF
[1]
SMDI
[2]