User`s manual

MediaPack
SIP User's Manual 126 Document #: LTRT-65408
5.5.10 Configuring RADIUS Accounting Parameters
The RADIUS Parameters screen is used for configuring the Remote Authentication Dial In
User Service (RADIUS) accounting parameters.
¾
To configure the FXO parameters, take these 4 steps:
1. Open the ‘RADIUS Parameters' screen (Protocol Management menu > RADIUS
Parameters); the ‘RADIUS Parameters' screen is displayed.
Figure 5-32: RADIUS Parameters Screen
2. Configure the RADIUS accounting parameters according to Table 5-33.
3. Click the Submit button to save your changes.
4. To save the changes so they are available after a power fail, refer to Section 5.10.2 on
page 205.
Table 5-32: RADIUS Parameters
Parameter Description
Enable RADIUS
EnableRADIUS
Enables or disables the RADIUS application.
Valid options include:
Disables
[0] = disables RADIUS application (default)
Enable
[1] = enables RADIUS application
RADIUS Accounting Server
IP Address
[RADIUSAccServerIP]
IP address of the RADIUS accounting server.
RADIUS Accounting Port
[RADIUSAccPort]
Port of the RADIUS accounting server.
The default value is 1646.
RADIUS Accounting Type
[RADIUSAccountingType]
Determines when the RADIUS accounting messages are sent to the RADIUS
accounting server.
Valid options include:
At Call Release
[0] = At the release of the call only (default).
At Connect and Release
[1] = At the connect and release of the call.
At Setup and Release
[2] = At the setup and release of the call.
AAA Indications
[
AAAIndications]
Determines which Authentication, Authorization and Accounting (AAA) indications
to use.
Valid options include:
None
[0] = No indications (default)
Accounting Only
[3] = Only accounting indications are used.