User`s manual

SIP User's Manual 5. Web Management
Version 5.0 123 December 2006
¾ To configure the Generate Caller ID to Tel Table, take these 5
steps:
1. Open the ‘Generate Caller ID to Tel’ screen (Protocol Management menu >
Endpoint Settings > Generate Caller ID to Tel option); the ‘Generate Caller ID to
Tel’ screen is displayed.
Figure 5-30: MediaPack FXS Generate Caller ID to Tel Screen
2. In the ‘Caller ID’ field, select one of the following:
• Enable: Enables Caller ID generation (FXS) or detection (FXO) for the specific
port.
• Disable: Caller ID generation (FXS) or detection (FXO) for the specific port is
disabled.
• Empty: Caller ID generation (FXS) or detection (FXO) for the specific port is
determined according to the parameter ‘EnableCallerID’ (described in Table 5-9).
3. Repeat step 2 for each port.
4. Click the Submit button to save your changes.
5. To save the changes so they are available after a power fail, refer to Section 5.10.2 on
page 205.
Table 5-30: Generate Caller ID to Tel ini File Parameter
Parameter Name in ini File Parameter Format
EnableCallerID_X
EnableCallerID_<Port> = <Caller ID>
Caller ID:
0 = Disabled (default).
1 = Enabled.
If not configured, use the global parameter ‘EnableCallerID’.
Note 1: The numbering of ports starts with 0.
Note 2: This parameter can appear up to eight times for 8-port
gateways, and up to 24 times for MP-124.