User`s manual

MediaPack
SIP User's Manual 120 Document #: LTRT-65408
5.5.9.2 Automatic Dialing
Use the Automatic Dialing Table to define telephone numbers that are automatically dialed
when a specific port is used.
¾
To configure the Automatic Dialing table, take these 6 steps:
1. Open the ‘Automatic Dialing’ screen (Protocol Management menu > Endpoint
Settings submenu > Automatic Dialing option); the ‘Automatic Dialing’ screen is
displayed.
Figure 5-28: Automatic Dialing Table Screen
2. In the ‘Destination Phone Number’ field for a port, enter the telephone number to dial.
3. From the ‘Auto Dial Status’ drop-down list, select one of the following:
• Enable [1]: When a port is selected, when making a call, the number in the
Destination Phone Number field is automatically dialed if phone is offhooked (for
FXS gateways) or ring signal is applied to port (FXO gateways).
• Disable [0]: The automatic dialing option on the specific port is disabled (the
number in the Destination Phone Number field is ignored).
• Hotline [2]: When a phone is offhooked and no digit is pressed for
‘HotLineToneDuration’, the number in the Destination Phone Number field is
automatically dialed (applies to FXS and FXO gateways).
4. Repeat step 3 for each port you want to use for Automatic Dialing.
5. Click the Submit button to save your changes.
6. To save the changes so they are available after a power fail, refer to Section 5.10.2 on
page 205.
Notes:
• After a ring signal is detected, on an ‘Enabled’ FXO port, the
gateway initiates a call to the destination number without seizing the
line. The line is seized only after the call is answered.
• After a ring signal is detected on a ‘Disabled’ or ‘Hotline’ FXO port,
the gateway seizes the line.