User`s manual

SIP User's Manual 5. Web Management
Version 5.0 117 December 2006
5.5.8 Configuring the Hunt Group Settings
The Hunt Group Settings Table is used to determine the method in which new calls are
assigned to channels within each hunt group. If such a rule doesn’t exist (for a specific hunt
group), the global rule, defined by the Channel Select Mode parameter (Protocol Definition
> General Parameters), applies.
¾
To configure the Hunt Group Settings table, take these 8 steps:
1. Open the ‘Hunt Group Settings’ screen (Protocol Management menu > Hunt Group
Settings); the ‘Hunt Group Settings’ screen is displayed.
Figure 5-26: Hunt Group Settings screen
2. From the 'Routing Index' drop-down list, select the range of entries that you want to
edit (up to 24 entries can be configured).
3. In the 'Hunt Group ID' field, enter the hunt group ID number.
4. From the 'Channel Select Mode' drop-down list, select the Channel Select Mode that
determines the method in which new calls are assigned to channels within the hunt
groups entered in the field to the right of this field. For information on available
Channel Select Modes, refer to Table 5-26 on page 118.
5. From the 'Registration Mode' drop-down list, select the registration mode.
6. Repeat steps 4 and 5, for each defined hunt group.
7. Click the Submit button to save your changes.
8. To save the changes so they are available after a power fail, refer to Section 5.10.2 on
page 205.