User`s manual

MediaPack
SIP User's Manual 116 Document #: LTRT-65408
Table 5-25: Endpoint Phone Number Table (continues on pages 115 to 116)
Parameter Description
Hunt Group ID In each of the Hunt Group ID fields, enter the hunt group ID (1-99) assigned to the
channel(s). The same hunt group ID can be used for more than one channel and
in more than one field.
The hunt group ID is an optional field that is used to define a group of common
behavior channels that are used for routing IP to Tel calls. If an IP to Tel call is
assigned to a hunt group, the call is routed to the channel or channels that
correspond to the hunt group ID.
You can configure the Hunt Group Settings table to determine the method in
which new calls are assigned to channels within the hunt groups (refer to Section
5.5.8 on page 117).
Note: If you enter a hunt group ID, you must configure the IP to Hunt Group
Routing Table (assigns incoming IP calls to the appropriate hunt group). If you do
not configure the IP to Hunt Group Routing Table, calls don’t complete.
For information on how to configure this table, refer to Section
5.5.5.3.
Profile ID Enter the number of the Tel profile that is assigned to the endpoints defined in the
‘Channel(s)’ field.
Parameter Name in ini File Parameter Format
TrunkGroup_x
TrunkGroup_<Hunt Group ID> = <Starting channel> - <Ending channel>, <Phone
Number>, <Tel Profile ID>
For example:
TrunkGroup_1 = 1-4,100
TrunkGroup_2 = 5-8,200,1
Note 1: The numbering of channels starts with 1.
Note 2: ‘Hunt Group ID’ can be set to any number in the range 1 to 99.
Note 3: This parameter can appear up to 8 times for 8-port gateways and up to
24 times for MP-124 gateways.
Note 4: An optional Tel ProfileID (1 to 4) can be applied to each group of
channels.
ChannelList
This parameter is obsolete; use instead TrunkGroup_x.