User`s manual

MP-1xx/H.323 User’s Manual 7. Device Management

Version 4.2 Beta 93 June 2003

Figure 7-16: Phone Number Manipulation Table for IP ! Tel calls

In Figure 7-16 above, the 1

rule adds "972" prefix to all numbers starting with "03". The 2

rule

first deletes 4 digits from all numbers starting with "1001" and then the digit "5" is added as prefix.

The 3

rule deletes all digits except for the last four, from all numbers starting with 123451001

and adds the digit "8" as a prefix.

For example, number 035000 is changed to 972035000, number 1001876 is changed to 5876

and number 1234510012001 is changed to 82001.

7.2.4.10 Set Up Gateway Endpoints' Phone Numbers

“Endpoint’s Phone Numbers” table is used to allocate phone numbers to Gateway ports, and

to enable/disable Gateway ports. The table defines phone numbers for Gateway endpoints. The

endpoints that aren’t defined are disabled. In Channel(s) field a range of endpoints can be

entered, such as “1-8” for MP-108, or “1-24” for MP-124. For a single endpoint, a single number

can be entered in the channel(s) field. Hunt Group ID can optionally be configured to define a

group of channels, which will be used for routing IP ! Tel calls with common rules. Figure 7-17

on the next page, shows the Endpoint’s Phone Numbers table.

Figure 7-17: Endpoint’s Phone Number Table

7.2.4.11 Set Up Automatic Dialing Table

“Automatic Dialing Table” defines destination numbers for Tel % IP calls. It can be used if

“Automatic Dialing” feature is enabled (IsDialNeeded = 1). The table is applicable for FXS and

FXO analog Gateways, for outgoing, Tel % IP calls. The table contains pre configured phone

numbers per Gateway port. The number is automatically dialed if phone is picked up (for FXS