User`s manual

MP-1xx/H.323
MP-1xx/H.323 User’s Manual 66 Document #: LTRT-00651
Table 6-3: H.323 Parameters (continues on pages 59 to 67)
ini File Field Name
GUI Parameter Name
*
Valid Range and Description
3 = Data Numbering Plan
4 = Telex Numbering Plan
8 = National Standard Numbering Plan
9 = Private Numbering Plan
15 = Reserved for extension
The Number Plan (NPI) parameter is used in H.225 Setup messages.
Not all the Combinations of TON/NPI are allowed. Usually, you need to select one of the
following TON/NPI sets:
0/0 (Unknown/Unknown),
1/1 (International/ISDN)
2/1 (National/ISDN)
4/1 (Subscriber/ISDN)
Note: Numbering Plan/Type in the Number Manipulation table, if presented, will override
the value defined by the global parameter, Using the Number Manipulation table enables
configuration of the Numbering plan and Type on a per call basis, according to
destination (or source) number.
SourceNumberType
Same as DestNumberType
SourceNumberPlan
Same as DestNumberPlan.
NumberMapTel2IP
(Manipulation Tables:
TEL ! IP Destination
Numbers)
a,b,c,d,e,f
a = Phone number prefix
b = Number of stripped digits
c = New prefix to be added, or "none"
d = Number of remained digits from right
e = H.225/Q.931 Number Plan
f = H.225/Q.931 Number Type
The parameter defines rule(s) for changing the destination phone number, received in
Tel! IP incoming call. Each rule is applied to a number that matches the "a" prefix.
The "b" and "c" actions apply to a number that starts with "a" prefix. The actions apply to
the number in the following order: "b", "d" and then "c".
Parameters can be skipped by "$$", such as NumberMapTel2IP=01,2,972,$$,0,0
NumberMapIP2Tel
(Manipulation Tables:
IP ! TEL Destination
Numbers)
a,b,c,d
a = Phone number prefix
b = Number of stripped digits
c = New prefix to be added, or "none"
d = Number of remained digits from right
The parameter defines rule(s) for changing the destination phone number, received in
IP!Tel call. Each rule is applied to a number that matches the "a" prefix.
The "b" and "c" actions apply to a number that starts with "a" prefix. The actions apply to
the number in the following order: "b", "d" and then "c".
SourceNumberMapTel2IP
(Manipulation Tables:
TEL ! IP Source Numbers)
Same rules as for destination number
SourceNumberMapIP2Tel
(Manipulation Tables:
IP ! TEL Source Numbers)
Same rules as for destination number
RouteModeIP2Tel
(IP to Tel Routing Mode)
0 – Route calls before number manipulation (default)
1 – Route calls after number manipulation
Defines order between routing calls to Hunt group and manipulation of destination
number.
RouteModeTel2IP
(Tel to IP Routing Mode)
0 – Route calls before number manipulation (default)
1 – Route calls after number manipulation
Defines order between routing incoming calls to IP, using routing table, and manipulation
of destination number.
Not applicable if GK is used.
EnableBusyOut
0 – Not used (default)
1 – If LAN or GK is not responding, the Gateway will play a reorder tone on phone
OffHook.