User`s manual
MP-1xx/H.323 User’s Manual 6. Provisioning
Version 4.2 Beta 61 June 2003
Table 6-3: H.323 Parameters (continues on pages 59 to 67)
ini File Field Name
GUI Parameter Name
*
Valid Range and Description
Channel2Phone
Phone number of channel.
Its format: Channel2Phone = “<channel>, <number>”
<channel> is 0...23.
Example: “Channel2Phone = 0, 1002”
Appears once for each channel: 8 times for MP-108, or 4 times for MP-104 and twice for
MP-102.
For 8-port and 24-port Gateways it is suggested to use “ChannelList = “ parameter,
where in a single line, all Gateway’s phone numbers can be defined. The
“Channel2Phone” can be used instead or in addition to “ChannelList = “ parameter.
TrunkGroup_x
(Trunk Group Table)
a-b,c or just a,c
x – Hunt group ID, starting with 1
a – Starting port (from 1)
b – Ending port (up to 24 for MP-124)
c – phone number allocated for the first port
For example:
TrunkGroup_1 = 1-4,100
TrunkGroup_2 = 5-8,200
Trunk Group can be used instead of ChannelList and Channel2Phone parameters. It can
be used for both FXS and FXO Gateways.
EnableHold
(Enable Hold)
0 – Disable Hold
1 – Enable Hold service (H.450.4)
If enabled the Hold (or unhold) is activated at FXS Gateway by HookFlash. On receipt of
Hold request, the remote party is put on hold, and plays hold tone to tel port.
EnableTransfer
(Enable Transfer)
0 – Disable Call Transfer (default)
1 – Enable call transfer service (H.450.2)
Transfer is initiated at FXS Gateway by HookFlash signaling. If service is enabled the
remote party will perform the call transfer.
EnableForward
(Enable Forward)
0 – Disable call forward (default)
1 – Enable call forward service (H.450.3).
For MP-1xx FXS Gateways a "Call forward table" should be used to define call forward
modes (refer to the ForwardInfoX parameter).
ForwardInfoX
a,b,c
x – Gateway port number (1 to 24)
a – Call forward mode
0 – not in use
1 – On busy
2 – Immediate forward
3 - No reply for time "c"
b – Forwarded number
c – Timeout [sec] for no reply
Incoming IP!Tel call will be forwarded to "b" number on one of the conditions: busy,
immediate or no reply.
Applicable only for MP-1xx/FXS Gateways
IsFaxUsed
0 = No
1 = Fax is send/received using H.323 Annex D T.38 procedure.
DetFaxOnAnswerTone
0 = Receiving Gateway initiates T.38 on receiving HDLC preamble signal from Fax
(default)
1 = Receiving GW initiates T.38 on receiving of CED answer tone from Fax.