User`s manual

MP-1xx/H.323
MP-1xx/H.323 User’s Manual 54 Document #: LTRT-00651
6.1.1 Basic, Logging and Web Parameters
Table 6-1: Basic and Logging Parameters (continues on pages 54 to 55)
ini File Field Name
GUI Parameter Name
*
Valid Range and Description
MGControlProtocolType
4 = for H.323 Gateway
DSPVersionTemplateNumber
0 = Firmware DSP version supports PCM/ADPCM, G723 and G729
Coders (default)
1 = Firmware DSP version supports PCM/ADPCM, and NetCoder coders
2 = Same as "0" but with voice and energy detectors
3 = Same as "1" but with voice and energy detectors
DSP templates 2 or 3 should be selected for FXO Gateway Disconnect
supervision feature, enabled by: "EnableSilenceDisconnect = 1".
EthernetPhyConfiguration
0 = 10 Base-T half-duplex
1 = 10 Base-T full-duplex
2 = 100 Base-T half-duplex
3 = 100 Base-T full-duplex
4 = auto-negotiate (Default)
Auto-negotiate falls back to half-duplex mode (HD) when the opposite port
is not in auto-negotiate, but the speed (10 Base-T, 100 Base -T) in this
mode is always configured correctly.
DNSPriServerIP
(DNS Primary Server IP)
IP address of primary DNS server
DNSSecServerIP
(DNS Secondary Server IP)
IP address of secondary DNS server
DHCPEnable
(Enable DHCP)
0 – Disable (default)
1 – Enable
After the Gateway is powered up it will try first to communicate with BootP
server. If BootP server is not responding and " DHCPEnable =1" the
Gateway will send DHCP request to configure its IP address and other
network parameters from enterprise DHCP server.
The DHCPEnable is a special "Hidden" parameter. Once defined and
saved in the flash memory, it is used even if it doesn't appear in the ini
file.
BootPRetries
1 = Single BootP request.
2 = 2 BootP retries - (3 seconds).
3 = 3 BootP retries - (default, 6 seconds)
4 = 10 BootP retries - (30 seconds).
5 = 20 BootP retries - (60 seconds).
6 = 40 BootP retries - (120 seconds).
7 = 100 BootP retries - (300 seconds).
15 = BootP retries forever.
Number of BootP retries, and then DHCP retries (if DHCPEnable = 1) at
Gateway startup.
The DHCPEnable is a special "Hidden" parameter. Once defined and
saved in the flash memory, it is used even if it doesn't appear in the ini
file.
Note that BootPRetries parameter becomes active after the MP-1xx is reset and ini file is loaded. To change the
parameters, first modify the ini file, and then reset the Gateway.
EnableDiagnostics
0 = No diagnostics (default)
1 = Perform diagnostics
WatchDogStatus
0 = Disable Gateway’s watch dog
1 = Enable Gateway’s watch dog (default)
EnableLanWatchDog
0 – Disable LAN WatchDog (default)
1 – Enable LAN WatchDog
MP-1xx will be restarted if LAN failure is detected
SysLogServerIP
(SysLog Server IP Address)
IP address in dotted format notation, e.g., ‘192.10.1.255’