User`s manual

MP-1xx/H.323 User’s Manual 5. Profiling & Operation
Version 4.2 Beta 51 June 2003
TargetOfChannel2 = 202
TargetOfChannel3 = 203
TargetOfChannel4 = 204
TargetOfChannel5 = 205
TargetOfChannel6 = 206
TargetOfChannel7 = 207
; Phones to IP routing table
;------------------------------------
Prefix = 20,10.1.10.2
5.5.4.4 MP-108/FXO configuration (using the FXO ini file)
$ To Configure the MP-108/FXO ini file take these 4 steps:
1. Configure in FXO ini file the endpoint numbers from 200 to 207.
2. Configure TargetOfChannel table to include phone numbers of the MP-108/FXS Gateway:
such as TargetOfChannel0= 100 (when ringing signal is detected at port #0 of FXO
Gateway, the FXO Gateway automatically dials “100” number).
3. Configure IP to phone table, to IP address and numbers of the FXS Gateway: such as
Prefix=10,10.1.10.3 (where 10.1.10.3 is an IP address of MP-108/FXS).
4. Set ‘IsDialNeeded = 0’ to activate automatic dialing when ringing is detected at FXO port.
IsDialNeeded = 0
;------------------------------------
; Phone of each end point
;------------------------------------
ChannelList = 0,8,200
;------------------------------------
; Automatic dialed numbers
;------------------------------------
TargetOfChannel0 = 100
TargetOfChannel1 = 101
TargetOfChannel2 = 102
TargetOfChannel3 = 103
TargetOfChannel4 = 104
TargetOfChannel5 = 105
TargetOfChannel6 = 106
TargetOfChannel7 = 107
;------------------------------------
; Phones to IP routing table
;------------------------------------
Prefix = 10,10.1.10.3