User`s manual

MP-1xx/H.323

MP-1xx/H.323 User’s Manual 48 Document #: LTRT-00651

5.5 Configuration Examples

Note 1: The MP-124 24-port, MP-108 8-port, MP-104 4-port and MP-102 2-port Media Gateways have

identical functionality (the MP-124 and MP-102 Gateways support FXS only), except for the

number of channels, and are referred to collectively in this manual as the MP-1xx.

Note 2: For simplicity, the MP-108 8-port Media Gateway is used in the following examples.

5.5.1 Establishing a Call between Two Gateways

In this demo, using MP-108 FXS Gateways as an example, a call can be made from an end-point

in one Gateway to an end-point in another Gateway.

$ To Configure the ini file parameters take next 9 steps:

1. Do NOT use Gatekeeper.

2. End point numbers of the first Gateway: 101…108.

3. End point numbers of the second Gateway: 201...208.

4. Internal routing prefix table should contain the IP address of the first MP-108 for

numbers starting with 10 and the IP address of the second Gateway for numbers

starting with 20

5. Prefix = 10, IP address of first MP-108.

6. Prefix = 20, IP address of second MP-108.

7. Start MP-108 Gateways and download the configuration ini file

8. Make a call from one end-point to the other.

5.5.2 Using Two Gateways with Gatekeeper

In this demo, a call can be made from an end-point in one Gateway to an end-point in another.

$ To Configure the ini file parameters take next 8 steps:

1. Use Gatekeeper.

2. In “GatekeeperIp”, insert the IP of the PC that runs the Gatekeeper.

3. End point numbers of the first MP-108 Gateway: 101...108

4. End point numbers of the second MP-108 Gateway: 201...208

5. Run Gatekeeper on the PC or laptop.

6. Start MP-108 Gateways and download the configuration ini file

7. Make a call from one end-point to the other.

8. Display the Gatekeeper log messages to show the Gatekeeper activities.

5.5.3 Using Gateway with NetMeeting™

In this demo, a call can be made from an end-point in one Gateway to NetMeeting™.

$ To Configure ini file parameters take next 7 steps:

1. Configure end point numbers of the MP-108/FXS Gateway: 101...108

2. Configure NetMeeting IP address using prefix definition:

Prefix = ’200Netmeeting IP address’.