User`s manual

MP-1xx/H.323 User’s Manual 4. Software Installation
Version 4.2 Beta 31 June 2003
5. In the ‘Quick Setup’ screen set the Gateway’s new IP Address, NAT IP Address, Subnet
Mask and Default Gateway IP Address.
6. Set the basic H.323 Gateway Parameters, as shown in Figure 4-2 below.
Figure 4-2: H.323 Quick Setup
7. Open the "End Point Phone Number” table and fill in the Gateway phone numbers. For
example, for MP-108, enter “1-8” in ‘Channel(s)’ field and starting Phone number, such
as 101 in adjacent ‘Phone number’ field. The MP-108 physical ports are associated with
phone numbers 101 to 108. You don't need to fill the ‘Hunt Group ID’ column. Click
the Submit button and close the window.
Figure 4-3: Endpoints' Phone Numbers
8. When working without a Gatekeeper the "Tel to IP Routing" table needs to be defined:
Fill in the “Destination phone prefix” (prefix of called number) and the associated IP
address. In the following example, an outgoing (Tel->IP) call with called number starting
with 512 is sent to IP address 10.2.201.11; while all other numbers starting with 51 are
sent to IP address 10.2.201.12. Assuming that the Gateway IP address is 10.2.1.1, all
local calls starting with "10" (such as 101-108) are routed back to the Gateway. When
Gatekeeper is used, the routing table can be used optionally as fallback in case of
failure. Click the submit button and close the window.