User`s manual

MP-1xx/H.323
MP-1xx/H.323 User’s Manual 30 Document #: LTRT-00651
utility, convert the text ini file to binary dat file. This procedure is described in Section 6.4.
The Coeff_FXS.dat and Coeff_FXO.dat files can be used respectively to modify the MP-1xx/FXS
and MP-10x/FXO telephony interface characteristics, such as DC and AC impedance, feeding
current and ringing voltage. For more information, refer to Section 6.5
4.3 Quick Setup Procedure
The following procedure describes how to setup the MP-1xx Gateway with basic parameters
using standard Web browser (such as Microsoft Explorer). It is assumed that the IP address of
the Gateway is known. If the IP address is unknown, use AudioCodes Configuration utility (or any
standard BootP server) to set the Gateway IP address and subnet mask.
Usually the MP-1xx Gateways are shipped with the following network parameters:
• MP-1xx FXS Gateway IP address: 10.1.10.10
• MP-10x FXO Gateway IP address: 10.1.10.11
• Subnet: 255.255.0.0
• Default Gateway: 0.0.0.0
$ For quick MP-1xx setup, take the next 12 steps:
1. Power-up the Gateway; after self-testing, in about 20 seconds the Ready LED on the
front panel turns to green. Any malfunction changes the Ready LED to red.
2. Before using your Web browser to access the MP-1xx’s Embedded Web Server,
change your PC’s IP address and Subnet Mask to correspond with the MP-1xx’s factory
default IP address and Subnet Mask.
3. Open any standard Web-browsing application such as Microsoft™ Internet Explorer™
(Ver. 5.0 and higher) or Netscape™ Navigator™ (Ver. 7.0 and higher) and specify the
IP address of the Media Gateway in the ‘Address’ field (e.g., http://10.1.10.10 for FXS);
the Embedded Web Server ‘Enter Network Password’ screen appears, Figure 4-1.
Figure 4-1: Web Browser Screen
4. Enter the User Name and Password (default: Admin, Admin). Note that the User Name
and Password fields are case-sensitive. Click OK; the ‘Quick Setup’ screen is accessed.