User`s manual

MP-1xx/H.323
MP-1xx/H.323 User’s Manual 106 Document #: LTRT-00651
Table 9-1: MP-1xx Functional Specifications (continues on pages 105 to 107)
Echo Canceler
G.168, 25 msec
DTMF Transport
Mute, transfer in RTP payload or relay in compliance with RFC 2833
DTMF Detection and
Generation
Dynamic range 0 to -25 dBm, compliant with TIA 464B and Bellcore TR-NWT-
000506.
Call Progress Tone Detection
and Generation
15 tones: single tone or dual tones, programmable frequency & amplitude; 16
frequencies in the range 300 to 2000 Hz, 1 or 2 cadences per tone, up to 2 sets of
ON/OFF periods.
Output Gain Control
Programmable -31 dB to +31 dB in steps of 1 dB
Input Gain Control
Programmable -31 dB to +31 dB in steps of 1 dB
Fax/Modem Relay
Fax Relay
Group 3 fax relay up to 14.4 kbps with auto fallback.
T.38 compliant, real time fax relay
Tolerant network delay (up to 9 sec round trip)
Modem Transparency
Auto switch to PCM or ADPCM on V.34 or V.90 modem detection
Protocols
VoIP Signaling Protocol
H.323 ITU, Version 4
Communication Protocols
RTP/RTCP packetization.
IP stack (UDP, TCP, RTP).
Remote Software download (TFTP & BootP support).
Line Signaling Protocols
Loop start, FXS and FXO
Interfaces
FXS Telephony Interface
2, 4, 8 or 24 Analog FXS phone or fax ports, loop start
FXO Telephony Interface
4 or 8 Analog FXO PSTN/PBX loop start ports
Network Interface
RJ-45 shielded connector, 10/100 Base-T.
RS-232 Interface
RS-232 Terminal Interface for maintenance and diagnostic reports. DB-9 connector
on rear panel
Life Line (MP-10x/FXS) Life Line, connected to the unused pins on port #4 (port #2 for MP-102/FXS), with a
relay to an analog line, even if the MP-10x/FXS is powered off (refer to Section 2.1.5
for details). Does NOT function with MP-124 and MP-10x/FXO Gateways.
Connectors & Switches
Rear Panel
24 Analog Lines (MP-124)
50-pin Telco shielded connector
8 Analog Lines (MP-108)
8 RJ-11 connectors
4 Analog Lines (MP-104)
4 RJ-11 connectors
2 Analog Lines (MP-102)
2 RJ-11 connectors
Ethernet
10/100 Base-T, RJ-45 shielded connector
RS-232
Console port - DB-9
Front Panel
Reset Resets the MP-1xx
Physical
MP-10x Enclosure Dimensions
Width: 221 mm 8.7 in
Height: 44.5 mm 1.75 in
Depth: 240 mm 9.5 in
Weight: 1.24 kg 2.5 lb
MP-124 Enclosure Dimensions
1U, 19-inch Rack
Width: 445 mm 17.5 in
Height: 44.5 mm 1.75 in
Depth: 269 mm 10.6 in
Weight: 2.24 kg 4.9 lb
Environmental
Operational: 0° to 45° C 32° to 113° F