Installation guide

Fast Track Installation Guide 7. Upgrading the MP-1xx
Version 4.6 35 July 2005
Figure 7-8: Auxiliary Files Screen
¾ To save the loaded auxiliary files to flash memory, take these 2 steps:
1. Click the Save Configuration button on the main menu bar; the ‘Save Configuration to the
Flash Memory’ screen is displayed.
Note: Saving an auxiliary file to flash memory may disrupt traffic on the MP-1xx. To
avoid this, disable all traffic on the device before saving to flash memory.
2. Click the Save Configuration button in the middle of the screen; a confirmation message
appears when the save is complete.
Note: A device reset is required to activate a loaded CPT file, and may be required
for the activation of certain ini file parameters.
¾ To reset the MP-1xx, take these 2 steps:
1. Click the Reset button on the main menu bar; the ‘Reset’ screen is displayed.
2. Click the Reset button in the middle of the screen; the auxiliary files are saved into flash and
the MP-1xx restarts. This takes approximately 1 minute to complete. When the MP-1xx has
finished restarting, the Ready and LAN LEDs on the front panel are lit green.