Installation guide
Table Of Contents
- 1. Quick Start
- 2. Installing the MP-1xx
- 3. Configuring the MP-1xx
- 4. Changing the MP-1xx Username and Password
- 5. Restoring and Backing Up the MP-1xx Configuration
- 6. Monitoring the MP-1xx
- 7. Upgrading the MP-1xx
- 8. MP-1xx IP<->PBX Test Example
- 9. Regulatory Information
Fast Track Installation Guide 7. Upgrading the MP-1xx
Version 4.6 33 July 2005
7. Follow the same procedure you followed when loading the ini file (refer to Step 6). The same
procedure applies to the ‘Load a VP file’ (not applicable to the MP-1xx gateway) screen and
‘Load a coefficient file’ screen.
8. In the ‘FINISH’ screen (refer to Figure 7-6), the Next button is disabled. Complete the
upgrade process by clicking
Reset or Cancel.
Button Result
Reset
The MP-1xx ‘burns’ the newly loaded files to flash memory. The ‘Burning files to flash
memory’ screen appears. Wait for the ‘burn’ to finish. When it finishes, the ‘End Process’
screen appears displaying the burned configuration files (refer to Figure
7-7).
Cancel
The MP-1xx resets, utilizing the files previously stored in flash memory. (Note that these
are NOT the files you loaded in the previous Wizard steps).
Figure 7-6: FINISH Screen
Figure 7-7: ‘End Process’ Screen
9. Click the End Process button; the ‘Quick Setup’ screen appears and the full Web application
is reactivated.