Installation guide

Fast Track Installation Guide 6. Monitoring the MP-1xx
Version 4.6 29 July 2005
6.2 Rear Panel LEDs
The LEDs on the rear panel are located within the RJ-45 socket. Table 6-2 describes the
meaning of each state of the LEDs on the rear panel.
Table 6-2: Definition of MP-1xx Rear Panel LED Indicators
Label Type Color State Definition
Yellow ON Ethernet port receiving data
ETH-1
Ethernet
Status
Red ON Collision
6.3 Monitoring the MP-1xx Channels
¾ To monitor the status of the channels:
• Open the Channel Status screen (Status & Diagnostics menu > Channel Status); the
Channel Status screen is displayed.
Figure 6-1: MP-1xx/FXS Channel Status Screen
The color of each channel shows the call status of that channel. Refer to Table
6-3 below for
information on the different statuses a call can have.
Table 6-3: Channel Status Color Indicators
Indicator Label Description
Inactive Indicates this channel is currently onhook
RTP Active Indicates an active RTP stream.
Not Connected
(FXO only)
Indicates that no analog line is connected to
this port.
Handset Offhook
Indicates this channel is offhook but there is
no active RTP session.
¾ To monitor the details of a channel, take these 2 steps:
1. In the Channel Status screen, click the numbered icon of the specific channel whose detailed
status you need to check/monitor; the channel-specific Channel Status screen appears.
2. Click the submenu links to check/view a specific channel’s parameter settings.