User`s manual

User's Manual 6. Configuring the MediaPack
Version 2.2 99 July 2007
 IP to Tel Source Number Manipulation Table for IP-to-Tel calls (refer to Section 'IP-to-
Tel Source Numbers' on page 102)
 Tel to IP Source Number Manipulation Table for Tel-to-IP calls (refer to Section 'Tel-
to-IP Source Numbers' on page 104)
Note: Number manipulation can occur either before or after a routing decision is
made. For example, you can route a call to a specific ISDN interface
according to its original number, and then you can remove or add a prefix
to that number before it is routed. To configure whether number
manipulation is performed before or after call routing, use the 'Routing &
Manipulation' parameter in the SIP Proxy & Registration screen (described
in Section 'SIP Proxy & Registration Settings' on page 82.
Note: the actions strip leave add are executed in the following order: strip (prefix/suffix); leave; add
(prefix/suffix)
6.2.2.6 IP-to-Tel Destination Numbers
The IP to Tel Destination Number Manipulation table is used to change the destination
number received in IP-to-telephone incoming calls. The table is processed from top to
bottom, where the first matching rule is used to manipulate the number. Processing stops
after the first manipulation.
Note: For a description on the convention for entering telephone numbers in the
Manipulation tables, refer to Section 'Convention for Entering Phone
Numbers in Tables' on page 66.
¾ To configure IP-to-Tel destination numbers:
1. Open the IP to Tel Destination Number Manipulation Table (Protocol Management
menu > Manipulation Tables submenu > IPÆTel Destination Numbers option).
Figure 6-10: IP to Tel Destination Number Manipulation Table
2. From the ‘Position' drop-down list, select the entry that you want to add.
3. Configure the number manipulation table according to Table 6-7.
4. Click the Insert button to insert an entry at the specified position.
5. To save the changes to the flash memory, refer to Section 'Saving Configuration
Settings on the MediaPack' on page 146.
You can modify an entry by clicking the Modify button and delete an entry by clicking the
Remove button.