User`s manual

User's Manual 6. Configuring the MediaPack
Version 2.2 95 July 2007
Table 6-5: ISDN Ports Parameters
Parameter Description
Admin State
[up|down]
The administrative status (up or down) of the interface.
Valid options include:
 Enable (default)
 Disable
Using CLI
To change the ISDN port parameters using CLI:
1. Log on to the system.
2. Change to the configuration mode.
3. From the main configuration mode, change to the “port pstn” mode.
4. To enter the "port pstn" mode, use the command:
port pstn 0 <0..3>
The last number indicates the port as labeled on the case.
5. Use the commands in square brackets ([]) to change the parameter values.
For more information on CLI, refer to Chapter
5.3 on page 68.