User`s manual

MediaPack BRI Series
User's Manual 94 Document #: LTRT-83702
6.2.2.2 ISDN Port Settings
The ISDN Port Settings option opens the 'ISDN Ports' screen. This screen allows you to
configure an individual BRI port.
¾ To configure the ISDN ports:
1. Open the ‘ISDN Ports’ screen (Protocol Management menu > ISDN submenu >
ISDN Port Settings option).
Figure 6-7: ISDN Ports Screen
2. From the 'ISDN Ports' list, select an ISDN port.
3. Configure the ISDN Ports parameters according to Table 6-5.
4. Click the Submit button to save your changes.
5. To save the changes to the flash memory, refer to Section 'Saving Configuration
Settings on the MediaPack' on page 146.
Table 6-5: ISDN Ports Parameters
Parameter Description
Uni-side
[uni-side <net|usr>]
Determines if the interface is user or network side.
 Net
 User (default)
Permanent-layer2
[[no]permanent-layer2]
Enables the system to attempt to keep the ISDN Layer 2 connection open.
Valid options include:
 Enable = permanent layer 2
 Disable (default)
Layer 2 mode
[l2proto <pp|pmp>]
Configures the layer 2 mode.
Valid options include:
 PP = point to point
 PMP (default) = point to multipoint
ISDN Interface
[[no]bind <if_num>]
Defines the ISDN interface (number) to which this port is assigned.
Valid range is 0 to 3. The default is <port num>.
For more information about ISDN interfaces, see Section
6.2.2.3 on page 96.