User`s manual

MediaPack BRI Series
User's Manual 86 Document #: LTRT-83702
Table 6-2: SIP Proxy and Registration Parameters (continues on pages 83 to 86)
Parameter Description
Using CLI
To define the SIP Proxy & Registration parameters using CLI:
1. Log on to the system.
2. Change to the configuration mode.
3. From the main configuration mode, change to the “context cs” mode.
4. From the “context cs” mode, change to the “interface sip” mode.
5. To enter the interface sip mode, use the command interface sip sip.
6. Use the command [[no[authPerGateway] as described above.
For more information on CLI, refer to Chapter
5.3 on page 68.
To define the default user name, perform the following:
1. Log on to the system.
2. Change to the configuration mode.
3. From the main configuration mode, change to the “gateway sip SIP” mode.
4. Enter the command:
user default name <name> secret <password> authuser <authname>
Where <name> is the user name, <password> is the password, and <authname> is the name used for
authentication.