User`s manual

User's Manual 6. Configuring the MediaPack
Version 2.2 85 July 2007
Table 6-2: SIP Proxy and Registration Parameters (continues on pages 83 to 86)
Parameter Description
Use Routing Table for
Host Names and Profiles
[[no]always-use-route-
table]
This parameter is applicable only if the proxy server is used.
Valid options include:
 Enabled = the domain field of the to header is set to the value determined by the
routing table.
 Disabled (default) = the domain field of the to header is set to the proxy.
Note: This parameter does not influence the destination to which the packet is sent.
Always use Proxy
[[no]forceProxy]
If this parameter is enabled, the system always uses the proxy server. If the proxy is
not on-line, the call fails.
Valid options include:
 Enabled
 Disabled (default)
Registration & Authentication Parameters
Authentication Mode
[[no] authPerGateway]
This parameter describes the authentication mode used to register / authenticate
with a proxy or gateway.
Valid options include:
 Per User = gateway registers only a single user and uses this user name and
password for call authentication.
 Per Gateway = registers a list of users defined in the SIP Users screen (refer to
Section 'SIP Users' on page 87). The gateway uses the list of users for call
authentication if a proxy or gateway requires authentication. The gateway
attempts to match the “from number” to select a user. If a match is found, this
user is used for authentication. If no user is found, the call fails.
Default User Name
User name used to register and authenticate with a registrar or to authenticate with a
proxy.
This user name is only used if the Authentication Mode parameter is set to Per
Gateway.
Default User Password
Password used to authenticate with a registrar or a proxy.
This password is only used if the Authentication Mode parameter is set to Per
Gateway.
Authentication User
User name used for authentication. If not defined, the user name is used.