User`s manual

User's Manual 6. Configuring the MediaPack
Version 2.2 79 July 2007
6 Configuring the MediaPack
This chapter provides step-by-step instructions for configuring the MediaPack. The
procedures described in this chapter are mainly targeted for those using the MediaPack's
embedded Web server. However, for those intending to use CLI, the CLI commands
corresponding to the Web interface's commands and parameters are also provided.
The MediaPack's embedded Web server consists of the following menus (on the menu
bar):
 Quick Setup (refer to Section 'Quick Setup' on page 79)
 Protocol Management (refer to Section 'Protocol Management' on page 79)
 Advanced Configuration (refer to Section 'Advanced Configuration' on page 118)
 Status & Diagnostics (refer to Section 'Status & Diagnostics' on page 142)
 Software Update (refer to Section 'Software ' on page 144)
 Load & Save Configuration (refer to Section 'Load & Save Configuration' on page 146)
 Reset (refer to Section 'Resetting the MediaPack' on page 154)
Note: Parameters enclosed in square brackets represent the corresponding Web
interface parameters and commands for configuring the MediaPack using
Command Line Interface (CLI).
6.1 Quick Setup
The Quick Setup menu provides a fast-and-easy method for configuring the basic
MediaPack parameters. This basic configuration includes, for example, LAN and WAN IP
addresses, SIP proxy, voice coders, ISDN, and various routing tables.
For a detailed description of the 'Quick Setup' screen and initial configuration procedures,
refer to Chapter 4 on page 39.
6.2 Protocol Management
The Protocol Management menu is used to configure the gateway’s SIP parameters,
ISDN parameters, number manipulation tables, call routing tables, and profiles.
The Protocol Management menu includes the following submenus:
 SIP Gateway (refer to Section 'SIP Gateway' on page 80)
 ISDN (refer to Section 'ISDN' on page 88)
 Manipulation Tables (refer to Section 'Manipulation Tables' on page 98)
 Routing Tables (refer to Section 'Routing Tables' on page 106)
 Profile Definitions (refer to Section 'Profile Definitions' on page 110)
 Call Progress Tone (refer to Section 'Configuring Call Progress Tones using CLI' on
page 91)