User`s manual

MediaPack BRI Series
User's Manual 70 Document #: LTRT-83702
5.3.3 Navigating in the CLI
After you log onto the gateway, you are in the Operator Execution mode. This mode allows
you to control the system with the help of a subset of the available commands.
To configure the device, you first need to change the Operator Execution mode to
Administrator Execution mode. To perform this, type the command enable. The
Administrator Execution mode offers you all the possible settings, and then you have to
enter the Configuration mode using the configure command.
To access various configuration modes, use the commands described in Table 5-3 on
page 71. To return to a previous configuration mode (i.e., from Configuration to
Administrator Execution mode), use the command exit.
5.3.4 Getting Acquainted with the CLI
The table below describes general CLI commands that you can use to facilitate the
MediaPack configuration while using CLI.
Note: The CLI commands are case-sensitive
Table 5-2: Useful CLI Command for Facilitating Configuration
Feature Perform this …
To display a list of all applicable commands of
an active mode
Type a question mark ('?') or press the Tab key.
The applicable commands are displayed at the
end of the list, separated by a line.
To display all possible options relevant to a
specific command
Type a question mark ('?') or press the Tab key
after the command name.
To automatically complete a command that's
partially typed
Press the Tab key.
Note: If the system is unable to complete the
command, it displays all the commands that
begin with the characters you have typed so far.
To view a list of previously executed commands
Use the up and down arrow buttons to navigate
through this list.
To repeat a command
Press Enter when at the respective position in
the list.
To delete a line from a table Type ‘no’ at the beginning of the command.
To disable a currently enabled command Type ‘no’ at the beginning of the command.