User`s manual

User's Manual 4. Initial Configuration
Version 2.2 59 July 2007
4.1.8 Configuring IP to Tel Routing Table
The IP to Tel Routing table is used to route incoming IP calls to the relevant ISDN
interface.
The procedure below describes how to configure IP-to-Tel call routing according to our
example setup: Incoming IP calls with destination number 1000 are to be routed to ISDN
interface number 0; while incoming IP calls with destination number 3000 are to be routed
to ISDN interface number 1.
¾ To route incoming IP calls to the relevant ISDN interface:
1. Open the ‘IP to Tel Routing Table’ screen (Protocol Management menu > Routing
Tables submenu > IP to Tel Routing option).
Figure 4-14: IP to Tel Routing Table Screen
2. Add the entries displayed in the figure above by performing the following:
a. From the ‘Position' drop-down list, select the entry that you want to add.
b. In the ‘Destination Number’ field, enter a called telephone number prefix.
c. From the ‘Destination Interface’ drop-down list, select the ISDN interface number
to which calls that match the destination number are routed.
d. Click the Insert button to add the entry.
For detailed information on the IP to Tel Routing table, refer to section 'IP to Tel Routing
Table' on page 108.