User`s manual

User's Manual 4. Initial Configuration
Version 2.2 57 July 2007
d. From the 'Authentication Mode' drop-down list, select one of the following:
♦ ’Per User’ (default): requires the configuration of the SIP users as described
in Step 4.
♦ ‘Per Gateway’: requires that you provide ‘Default user name’, ‘Default user
password’ and ‘Default user cnonce’
(In our example setup for Unit A, the Authentication mode is set to ’Per User’.)
e. Click the Submit button.
5. If in the 'SIP Proxy & Registration' screen the Authentication mode was set to ‘per
user’, perform the following:
a. Access the 'SIP Users' screen (Protocol Management menu > SIP Gateway
submenu > SIP Users option).
Figure 4-12: SIP Users Screen
b. Add the SIP users ‘Name’ (phone number) and ‘Password'. (In our example
setup for Unit A, SIP user ID 1 was defined with the name "1000" and without a
password; SIP user ID 2 was defined with the name "3000" and without a
password).
6. Click the Submit button.
7. In our example setup, verify that Users 1000@10.33.2.35 and 3000@10.33.2.35 are
registered at the Proxy Server 10.33.2.20.
For additional SIP-related parameters, refer to Section 'SIP Gateway' on page 80.
For detailed information on the parameters ‘Registration Time’ and ‘Authentication Mode’,
refer to refer to Table 6-2 on page 83.